MOOSE Z950 Bedienungsanleitung PDF herunterladen (Seite 19)

Bypassing Zones

The Bypass (#) key is used to bypass selected zones in your system. A bypassed

zone will NOT be capable of activating an alarm as it is temporarily removed from

your system. Bypassing (also referred to as shunting) is most commonly used to

allow free movement of an area (zone or group of zones) while arming the rest of the

system or to temporarily remove a zone or zones that require service, allowing partial

use of the system until repaired. When a zone is bypassed, its corresponding Zone

indicator will flash to indicate that is has been removed from operation. It may

continue to flash until 30 seconds after the system is armed or it may flash for entire

time that the system is armed. The installer can program how the flashing operates.

WARNING

WHEN ZONES ARE BYPASSED, SECURITY IS COMPROMISED. DO NOT

INSTRUCT TEMPORARY USERS ON USE OF THE BYPASS FEATURE.

To Bypass A Zone

1. The system must be disarmed.

2. Press the Bypass (#) key, then enter the number of the zone to

be bypassed.

3. The corresponding ZONE indicators will blink to indicate the

zones that have been bypassed. The blinking will cease after

the system is armed and the exit delay has expired. If Perma-

nent Force-Arming has been enabled, then the ZONE indica

tors for the bypassed zones will continue to blink during the

ARMED period.

4. Repeat steps 2 and 3 to bypass other zones.

To Cancel A Zone Bypass

1. The system must be disarmed.

2. Press the Bypass (#) key followed by the number of the zone to

be restored to service.

3. The ZONE indicator of the previously bypassed zone will stop

blinking.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 50 51

Keine Kommentare

MOOSE Z950 Bedienungsanleitung Seite 19