MOOSE Z950 Bedienungsanleitung PDF herunterladen (Seite 42)

Changing User Codes

Determine your desired new User Code or Master User Code sequence. If you

make an error while programming, press the Reset (*) key five times and start

over from step 1.

Pressing the Bypass (#) or Reset (*) key while programming a code may result in

improper code operation, therefore you MUST return to step I when an error is

made.

To Change A User Code

1. The system must be disarmed.

2. Press key 9 and hold for three seconds. The keypad will beep three

times.

3. Enter the Master User Code. The keypad will beep two times.

The READY and ARMED indicators will blink alternately, and

the other indicators will blink repeatedly when the programming mode is

successfully entered (see remote programming note on Page 3-

1).

4. Press a key (2-8) for Z950/Z880 or (2-6) for Z900 which corresponds to

the User Code you wish to program, or press key 1 to change the Master

User Code. Then press the Bypass (#) key. The keypad will beep three

times to signify acceptance.

5. Enter the desired new 4 digit code sequence. After the fourth digit is

entered, the keypad will emit one short beep followed by one long beep;

then the system will exit the programming mode automatically. To

program another code, return to step 2.

CAUTION

USE EXTREME CARE WHEN CHANGING OR DELETING CODES. DO NOT DELETE

MASTER USER CODE 1.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 50 51

Keine Kommentare

MOOSE Z950 Bedienungsanleitung Seite 42